REASSEMBLY (cont) - TM-10-3930-638-24-P0758

TM 10-3930-638-24&P

3-30. HYDRAULIC LIFT SYSTEM MAINTENANCE (cont)

e. Lift Cylinder Assembly (cont).

STEP

LOCATION

lTEM

ACTION

REMARKS

REASSEMBLY (cent )

2 4 A (cent)

Lubricate,

c . End cap as-

Use clean hydraulic oil (ref-

s e m b l y (16)

and in-

fer to current lubrication

stall

order). Tighten after

metal-to-metal contact

25 Cylinder (54) a. Tool

a. Install in tube cylinder and hand tighten

use of spanner wrench may be necessary

CAS1704-2

NOTE

If tool CAS1704-2 cannot be completely installed in cylinder (54),

c y l i n d e r may be distorted due to too much pressure exerted by vise.

L o o s e n vise grip on cylinder then repeat step 25a above.

b. Lubricate

U s e clean hydraulic oil (re-

fer to current lubrication

order)

b . Inner tube

P u l l completely out of outer tube (35)

(33)

u n t i l it bottoms in outer tube

CAUTION

When performing following steps, be careful not to damage parts.

c . Inner tube

a . With an assistant, slowly install

( 3 3 ) and

through tool CAS1704-2 and top of

o u t e r tube

cylinder (54) until piston assembly is

(35)

i n s i d e tool CAS1704-2

3-246D

Change 2