Tilt Cylinder Assemblies (cont). - TM-10-3930-638-24-P0730

TM 10-3930-638-24&P

3-30. HYDRAULIC LIFT SYSTEM MAINTENANCE (cont)

b. Tilt Cylinder Assemblies (cont).

LOCATION

ITEM

STEP

REMARKS

ACTION

CLEANING

WARNING

Dry cleaning solvent (P-D-680), used to clean parts is toxic and

flammable. Wear protective goggles and gloves and use only in a

well ventilated area. Avoid contact with skin, eyes, and clothes

and don't breathe vapors. Do not use near open flame or exces-

sive heat and don't smoke when using it. Failure to do so could

cause serious injury. If you become dizzy while using cleaning

solvent, get fresh air immediately, and get medical attention. If

contact with skin or clothes is made, flush with large amounts of

water. If contact with eyes is made, wash eyes with water immed-

iately, and obtain medical aid immediately.

WARNING

Wear safety glasses when drying parts with compressed air. Failure

to do so could cause serious injury to eyes and possible blindness.

If you hurt your eyes or if a foreign object is blown into your eyes,

seek medical attention immediately.

Use cleaning solvent P-D-680; dry with

All parts

Clean

compressed air

INSPECTION/REPAIR

Inspect

Replace if bent, deeply grooved, or

Rod (31)

scored. Remove nicks or scratches with

medium grit emery cloth polishing with

a rotary motion

Inspect

Replace if deeply grooved, scored, or

Cylinder (33)

damaged, Remove nicks or scratches

inside cylinder with medium grit emery

cloth polishing with a rotary motion

Bushing (30 and 32)

Inspect

Replace if worn, cracked or split

Inspect

Replace if damaged, cracked, split,

All other parts

grooved or scored

REASSEMBLY

Use 1-9/16 inches diameter sleeve; install

Bushing (32)

Install

Cylinder (33)

until flush

Install

Use 1-9/16 inches diameter sleeve; install

Bushing (30)

Rod (31)

until flush

3-222