 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-638-24&P
3-24. STEERING SYSTEM MAINTENANCE (cont)
b. Steering Gear (cont).
ITEM
LOCATION
STEP
ACTION
REMARKS
REASSEMBLY (cont)
34
Position slot side of commutator ring
Position
e. Commutator
toward housing (43), and lower over
ring (8)
and install
(cont)
guide studs and onto manifold (9)
Install
f. Seal retainer (5)
Assemble over rotor set (11) and down
against housing (43)
and new rotor
seal (4)
Position counterbore side of commutator
Position
g. Commutator (7)
and install
away from housing (43), and engage
slotted hole in commutator with nose
of drive link (10). Center commutator in
commutator ring to achieve equal spac-
ing as shown
Install
Apply a small amount of grease to one side
h. Wear washer (6)
of washer (6) and place washer over pin
on end cover (3). Grease should hold
washer in place when end cover is
inverted
i. End cover (3)
Position and
Lower end cover (3) over guide studs and
install
with wear
onto commutator ring (8)
washer (6)
j. Five hex bolts (2)
Install and
Tighten hand-tight only
tighten
k. Two guide studs
Remove
l. Two hex bolts (2)
Install and
Tighten hand-tight only
tighten
3-176
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals