 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-638-24&P
3-24. STEERING SYSTEM MAINTENANCE (cont)
b. Steering Gear (cont).
REMARKS
ITEM
ACTION
LOCATION
STEP
REASSEMBLY (cont)
32
NOTE
(cont)
Perform the following step only if retainer spring (33) has been
removed.
Carefully insert into groove on spool to
c. New retainer
Install
avoid scratching or nicking spool
spring (33)
Position
Over thrust washer (24) and bearing (23)
d. Spring washer (25)
e. Actuator ball (32)
Position
In ball seat located inside spool (30)
f. Input shaft (27)
Install in
Hold input shaft and spool in a horizontal
spool (30)
position. Insert input shaft into spool,
engaging the helix and actuator ball with
a counter-clockwise motion
Position
Use mid-section of torsion bar as a gage,
g. Torsion bar (28)
and insert torsion bar between spool end
and thrust washer (24) as shown
Position
Keeping torsion bar between spool end and
h. Input shaft (27)
vertically
with spool (30)
thrust washer, place shaft and spool in a
vertical position, with shaft end on a table
surface
Position drive ring in end of spool. Visual-
i. Drive ring (31)
Position and
ly align an internal space on drive ring wit
install
a tooth on input shaft spline, and allow
drive ring to drop to limit of its travel.
Rotate input shaft slightly to allow drive
ring to fully engage
3-172
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals