 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-638-24&P
3-24. STEERING SYSTEM MAINTENANCE (cont)
b. Steering Gear (cont).
REMARKS
ACTION
ITEM
LOCATION
STEP
Remove
Slide rotor set (11) on spacer (12), allow-
4
a. Drive link (10)
Rotor set (11)
ing drive link teeth to clear spacer hole.
From rotor set (11)
Separate
b. Spacer (12)
To protect against damage to side faces
c. Rotor set (11)
Carefully set
of rotor and stator
aside
CAUTION
5
Housing
(43)
To prevent distortion of steering gear, do not clamp vise jaws directly on
steering gear housing (43).
Reposition and
Clamp O-ring fitting in vise so that input
a. Housing (43)
shaft (27) faces upward
clamp
Match mark
Use center punch and hammer
b. Upper cover (14)
and housing (43)
Loosen and
Use 5/16 inch 12 point socket
c. Four cap screws (13)
remove
CAUTION
Do not use excessive force to remove spool (30) from housing
(43). Avoid applying side forces to input shaft (27) which would
cause binding of spool (30).
Remove from
Grasp input shaft (27) and, with a smooth
d. Upper cover (14),
upward motion, remove as an assembly
input shaft (27)
housing (43)
and, spool (30)
e. O-ring (15)
Remove and
discard
Upper
a. Input shaft (27)
Remove
6
cover (14)
Remove from
Retain shims for use at reassembly
b. Shims (17)
cover (14) or
face of thrust
washer (22)
c. Spacer (16)
Remove
Remove
Use snap ring pliers
d. Retaining ring (18)
Remove and
e. Back-up washer
(19) and seal (20)
discard
Remove
7
Input
a. Retaining ring (21)
shaft (27)
Pull and remove
b. Thrust washers (22
and 24), bearing (23)
and spring washer
(25)
3-165
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals