 |
|||
|
|
|||
|
Page Title:
Steering Wheel and Column (cont). |
|
||
| ||||||||||
|
|
 TM 10-3930-638-24&P
3-24. STEERING SYSTEM MAINTENANCE (cont)
a. Steering Wheel and Column (cont).
ITEM
STEP
LOCATION
REMARKS
ACTION
INSPECTION/REPAIR (cont)
Inspect
Replace if worn, or if threads damaged
Nuts (1 and 5) and
9
screws (7, 8, 11 and
21)
Inspect
Replace if cracked, or if serrations chip-
10
Steering wheel (4)
ped, broken or missing
Inspect
Jacket tube (15
11
Replace if cracked, distorted or out-of-
round, or if threads damaged
Inspect
Replace if worn, damaged or deteriorated
Bushing (14)
12
Inspect
Replace if worn or damaged
13
All other parts
REASSEMBLY
Position
On Upper cover of steering gear
Steering
a. Clamp (20)
14
Position
On wheel tube (23)
column
b. Horn-contact as-
sembly (22)
Install
c. Horn wire (17)
Install and
Until horn contact assembly (22) is secure-
d. Screw (21)
ly mounted
tighten
Position
On wheel tube (23), with slot in coupling
e. Coupling (19)
aligned with terminal on horn contact
assembly (22)
Install
Use 5/16 inch brass rod. Press or tap in
f. Dowel pin (18)
until centered in coupling (19)
NOTE
Perform the following step only if bushing (14) was removed.
Install
Using soft plastic hammer, lightly tap until
g. Bushing (14)
flush with top of jacket tube (15)
Position
On steering gear input shaft
h. Coupling (19) with
wheel tube (23)
CAUTION
Do not strike dowel pins (18) with heavy hammer blows in the
following step. Heavy hammer blows may damage bearing in
steering gear.
i. Two dowel pins (18)
Install
Lightly tap in using 5/16 inch brass rod
and hammer. Be sure dowel pins are
centered in coupling (19)
3-159
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals