Transmission Mounts (cont). - TM-10-3930-638-24-P0637

TM 10-3930-638-24&P

3-19. TRANSMISSION MAINTENANCE (cont)

b. Transmission Mounts (cont).

ITEM

REMARKS

LOCATION

ACTION

STEP

REMOVAL

Engine compart-

NOTE

ment, front

Remove and reinstall transmission mount on one side only; then

repeat procedure for remaining mount.

a. Lock nut (1) and

Loosen and remove Discard lock nut (1)

washer (2)

b. Cap screw (3)

If necessary, gently tap threaded end of

Lift and remove

cap screw using hammer

Place jack under transmission housing on

c. Transmission housing

Lift

same side as mount being removed.

Raise transmission and bracket (7) to

relieve pressure on mount (4)

d. Transmission mount

Pry and lift from vehicle frame

Remove and dis-

(4)

card

NOTE

Remove the following parts only if required for replacement.

e. Four cap screws (5)

Loosen and remove Support bracket (7)

and washers (6)

f. Mount bracket (7)

Remove

CLEANING

WARNING

Dry cleaning solvent (P-D-680), used to clean parts is toxic and

flammable. Wear protective goggles and gloves and use only in a

well ventilated area. Avoid contact with skin, eyes, and clothes

and don't breathe vapors. Do not use near open flame or exces-

sive heat and don't smoke when using it. Failure to do so could

cause serious injury. If you become dizzy while using cleaning

solvent, get fresh air immediately, and get medical attention. If

contact with skin or clothes is made, flush with large amounts of

water. If contact with eyes is made, wash eyes with water immedi-

ately, and obtain medical aid immediately.

Wear safety glasses when drying parts with compressed air.

Failure to do so could cause serious injury to eyes and possible

blindness. If you hurt your eyes or if a foreign object is blown

into your eyes, seek medical attention immediately.

3-131