 |
|||
|
|
|||
|
Page Title:
ALTERNATOR REPAIR (cont) |
|
||
| ||||||||||
|
|
 TM 10-3930-638-24&P
3-12. ALTERNATOR REPAIR (cont)
REMARKS
ACTION
ITEM
STEP
LOCATION
DISASSEMBLY (cont)
2
q. Outer terminal stud
Remove
(cont)
insulator (20)
r. Stud terminal (21)
Remove
s. Slip ring end frame
Position
On open jaws of vise, so jaws support area
around bearings
(2)
NOTE
Remove bearing (22) if worn, cracked, pitted or damaged, or if
grease supply is exhausted.
t. Bearing (22)
Remove and
Use valve guide installer tool and press out
discard
of end frame (2)
3
Drive end
frame (1)
CAUTION
Do not overtighten vise. Over tightening may distort and damage
rotor.
a. Rotor (23)
Mount
Use vise
b. Shaft nut (24)
Remove
c. Lock washer (25)
Remove and
discard
d. Shaft collar (26)
Remove
e. Drive end frame (1)
Remove
From rotor (23)
f. Three screws (27)
Remove
g. Ball bearing retainer
Remove
plate (28)
h. Bearing housing on
Back up
Use front cover seal installer tool
drive end frame (1)
Use valve guide installer tool and press bear-
Remove
i. Ball bearing (29)
ing out of end frame (1)
Remove and
j. Grease slinger
discard
washer (30)
CLEANING
CAUTION
Do not clean stator or rotor with cleaning solvent.
4
Clean
Wipe with clean, soft, absorbent, lintfree
Stator (4) and rotor
cloth
(23)
3-96
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals