 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-638-24&P
3 - 5 . ENGINE MAINTENANCE (cont)
k. Oil Pan (cont).
REMARKS
ACTION
ITEM
STEP
LOCATION
CLEANING (cont)
Use cleaning solvent P-D-680. Dry
All parts
2
Clean
thoroughly with compressed air
Oil pan (4) and engine
Scrape all gasket residue from mating
3
Clean
surfaces
INSPECTION
Replace if worn, or if threads damaged
4
Bolts (1 and 3) and drain Inspect
plug (6)
Replace if worn, cracked or deteriorated
5
Gasket (7)
Inspect
Repair if dented. Replace if cracked or
Oil pan (4)
Inspect
6
damaged so as to cause leakage
Replace if cracked, distorted or damaged
7
Reinforcement strip (2)
Inspect
REPAIR
Pound out small Use a hammer and wooden backing block
8
Oil pan (4)
to remove dents from oil pan. Be sure
dents
that gasket mating surface on oil pan is
not deformed
INSTALLATION/REPLACEMENT
9
Engine bottom
a. New gasket (5)
Apply Permatex 2 on both sides of
Coat and
gasket at front and rear portions only.
position
Position gasket on mating surface of oil
pan (4)
b. Oil pan (4)
On engine, with gasket holes in alignment
Position
c. Fourteen short bolts
Alternately tighten to 10-12 pounds foot
Install and
(3)
tighten
d. Reinforcement strip (2) Position
On oil pan (4)
e. Four long bolts (1)
Tighten to 15-20 pounds foot torque
Install and
tighten
f. Gasket (7) and drain
Tighten drain plug to 29-31 pounds foot
Install
plug (6)
10
Engine compart-
Engine
Install
ment
3-70
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals