 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-638-24&P
2-56. HYDRAULIC LIFT SYSTEM MAINTENANCE (cont)
c. Lifting Forks (cont).
ITEM
LOCATION
ACTION
REMARKS
STEP
REMOVAL
Remove
1
Carriage assem-
Cap screw and nut
bly, center
Position
Use 1-1 /2 inch diameter bar and hammer
2
Carriage assem-
Fork travel bar
to drive bar far enough through bore on
bly, left side
opposite side of carriage to remove fork
Lift end of fork
3
Carriage assem-
Lifting fork
to disengage from
bly, front
notch in support
and slide fork from
bar
Same as step 2
4
Fork travel bar
Carriage assem-
bly, right side
above
Same as step 3
5
Carriage assem-
Lifting fork
bly, front
above
INSTALLATION/REPLACEMENT
If necessary perform step 2 above to
Install on fork
Lifting fork
6
Carriage assem-
travel bar
position bar. Be sure you lift end of
bly, front right
fork to clear notches in support
Position
Use 1 -1/2 inch diameter bar and hammer
7
Fork travel bar
Carriage assem-
to drive bar into its bore on opposite
bly, left side
side of carriage. Continue driving bar
far enough through bore until remaining
fork can be installed
Install on fork
Be sure you lift end of fork to clear
Carriage mem-
Lifting fork
8
notches in support
travel bar
bly, left front
Drive bar into its bore on opposite side of
Position
9
Fork travel bar
Carriage assem-
carriage until holes in bar and center of
bly, right side
carriage are aligned
Install
Cap screw and nut
10
Carriage assem-
bly, middle
2-401
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals