Hood Panels and Hood Support Plates (cont).

TM 10-3930-638-24&P

2-53. BODY, CAB AND HOOD MAINTENANCE (cont)

e. Hood Panels and Hood Support Plates (cont).

ITEM

REMARKS

STEP

LOCATION

ACTION

REMOVAL

a. Two nuts (l), four cap

Engine compart-

Remove

screws (2 and 3), lock

ment, upper

washers (4), and

left or right side

washers (5)

b. Hood panel (6 or 7)

Remove

NOTE

If top hood is not removed (para 2-53d) you must remove six cap

screws, washers and lock washers.

Engine compart-

a. Three nuts (8), lock

Remove

washers (9), washers

ment, left or

right side

(10), and cap screws

(11)

Remove

Disconnect ground cable and remove

b. Two cap screws (12),

lock washers (13),

ground cable washer if left hood support

and washers (14)

plate (15) is being removed

c. Hood support plate

Remove

(15 or 16)

CLEANING

WARNING

Dry cleaning solvent (P-D-680), used to clean parts is toxic and

flammable. Wear protective goggles and gloves and use only in a

well ventilated area. Avoid contact with skin, eyes, and clothes

and don't breathe vapors. Do not use near open flame or exces-

sive heat and don't smoke when using it. Failure to do so could

cause serious injury. If you become dizzy while using cleaning

solvent, get fresh air immediately, and get medical attention. If

contact with skin or clothes is made, flush with large amounts of

water. If contact with eyes is made, wash eyes with water immed-

iately, and obtain medical aid immediately.

Use cleaning solvent P-D-680, Dry

All parts

Clean

thoroughly. Remove rust with stiff

wire brush

INSPECTION

Replace if cracked, damaged, broken,

All parts

Inspect

bent, distorted, or threads damaged

2-376