Fenders (cot). - TM-10-3930-638-24-P0407

TM 10-3930-638-24&P

2-53. BODY, CAB AND HOOD MAINTENANCE (cont)

b. Fenders (cont).

REMARKS

ITEM

LOCATION

ACTION

STEP

CLEANING

WARNING

Dry cleaning solvent (P-D-680), used to clean parts is toxic and

flammable. Wear protective goggles and gloves and use only in a

well ventilated area. Avoid contact with skin, eyes, and clothes

and don't breathe vapors. Do not use near open flame or exces-

sive heat and don `t smoke when using it. Failure to do so could

cause serious injury. If you become dizzy while using cleaning

solvent, get fresh air immediately, and get medical attention. If

contact with skin or clothes is made, flush with large amounts of

water. If contact with eyes is made, wash eyes with water immed-

iately, and obtain medical aid immediately.

Use cleaning solvent P-D-680. Dry

All parts

Clean

thoroughly. Remove rust using stiff

wire brush

INSPECTION

Replace if cracked, damaged, bent,

All parts

Inspect

broken, distorted or threads damaged

INSTALLATION

Position

a. Fender (18)

Engine compart-

Connect ground wire when installing rear

Install

ment, rear left

b. Nine washers (17), five

left fender

cap screws ( 16), lock

or right side

washers (15), and

nuts (14)

Left or right

a. Two plugs (13)

Install

Do not tighten; loosely install in fender

front fender (8)

b. Washer (12), cap screw

Install

(11), lock washer (10),

and nut (9)

Position assembled cap screw (11), and

a. Fender (8)

Position

Console support

washer (12), in slot in console support

bracket, left or

bracket

right side

b. Nut (9)

Tighten

Install

c. Cap screw (7), lock

washer (6), and nut (5)

a. Two washers (4)

Install

Chassis, front

b. Two cap screws (3)

Install

left or right

Install

c. Two lock washers (2)

side

d. Two nuts (1)

Install

2-369