Roll Over Protective Structure

TM 10-3930-638-24&P

2-52. FRAME AND TOWING ATTACHMENTS MAINTENANCE (cont)

a. Roll Over Protective Structure (cont).

REMARKS

ITEM

ACTION

LOCATION

STEP

REMOVAL

Tag and disconnect Located at bottom of ROPS, two on left,

a. Three wire leads

Operator's com-

one on right

partment

Secure

Attach hoist

b. Roll over protective

structure (9)

Remove

c. Two nuts (1), washers

(2), reinforcing plates

(3), washers (4), and

cap screws (5)

d. Two nuts (6), lock

Remove

washers (7), and

cap screws (8)

Use hoist

Remove

e. Roll over protective

structure (9)

f. Two nuts (10), lock

Remove

washers (11), washers

(12), and cap

screws (13)

Remove

g. Two brackets (14)

NOTE

Don't perform following step unless inspection indicates re -

placement of canopy headlining (15) is necessary.

h. Canopy headlining

Remove only if

(15)

damaged

CLEANING

WARNING

Dry cleaning solvent (P-D-680), used to clean parts is toxic and

flammable. Wear protective goggles and gloves and use only in a

well ventilated area. Avoid contact with skin, eyes, and clothes

and don't breathe vapors. Do not use near open flame or exces-

sive heat and don't smoke when using it. Failure to do so could

cause serious injury. If you become dizzy while using cleaning

solvent, get fresh air immediately, and get medical attention. If

contact with skin or clothes is made, flush with large amounts of

water. If contact with eyes is made, wash eyes with water immed-

iately, and obtain medical aid immediately.

ALL parts

Clean

Use cleaning solvent P-D-680. Dry

thoroughly

2-356 CHANGE 2