Center Drive Shaft Assembly (cont). - TM-10-3930-638-24-P0277

TM 10-3930-638-24&P

2-39. AXLES AND DRIVE SHAFT ASSEMBLIES MAINTENANCE (cont)

b. Center Drive Shaft Assembly (cont).

STEP

ITEM

LOCATION

ACTION

REMARKS

CLEANING

WARNING

Dry cleaning solvent (P-D-680), used to clean parts is toxic and

flammable. Wear protective goggles and gloves and use only in a

well ventilated area. Avoid contact with skin, eyes. and clothes

and don't breathe vapors. Do not use near open flame or exces-

sive heat and don't smoke when using it. Failure to do so could

cause serious injury. If you become dizzy while using cleaning

solvent, get fresh air immediately, and get medical attention. If

contact with skin or clothes is made, flush with large amounts of

water. If contact with eyes is made, wash eyes with water immed-

iately, find obtain medical aid immediately.

Use clean cloth moistened with cleaning

Universal joint (3)

Clean

solvent P-D-680

Use cleaning solvent P-D-680

All other parts

Clean

INSPECTION

Universal joint (3),

Replace if cracked, threads damaged,

Inspect

splines twisted, teeth broken, bent, or

splined yoke (9),

otherwise damaged. Remove burrs with

and slip yoke (10)

soft honing stone or crocus cloth

Replace if cracked or threads damaged

All other parts

Inspect

REASSEMBLY/REPAIR

Center drive shaft a. Cap (6), washers

Position on splined

(7 and 8)

assembly

yoke (9)

b. Splined yoke (9)

Insert into slip

yoke (10)

Position against

c. Washers (7 and 8) and

cap (6)

slip yoke (10);

tighten cap (6)

Install

d. Lubrication fittings

(4 and 5)

Position

c. Two universal joints

(3)

Install

f. Eight cap screws (2)

Install

and nuts (3)

2-241