Rear. Blackout Lights

TM 10-3930-638-24&P

2-30. LIGHT SYSTEMS MAINTENANCE (cont)

c. Rear. Blackout Lights.

d. Installation/ Replacement

This task covers: a. Removal

e. Testing

b. Cleaning

c. Inspection

INITIAL SETUP

EQUIPMENT CONDITION

TOOLS

Paragraph

Condition Description

NSN 4910-00-754-0654

No. 1 Common Organiza-

Engine off.

tional Maintenance Tool Kit

IGNITION switch in OFF position and

key removed.

MATERIALS/PARTS

2-52c

Tow bar lowered to ground and grille open.

Cleaning solvent P-D-680

Clean cloths

ACTION

REMARKS

ITEM

STEP

LOCATION

REMOVAL

Loosen

Rear of vehicle

a. Six screws (1)

b. Door (2) and gasket (3)

Remove

Depress, turn

c . Two bulbs (4)

counterclock-

wise and remove

From light assembly leads

d. Two harness

Grasp and pull

connectors (6)

e. Two cap screws (7) and

Remove

Support body (13)

lock washers (8)

Remove

f. Body (13)

Support socket assembly (12)

Remove

g. Five screws (9 and

11) and two

washers (10)

From body (13)

Remove

h. Socket assembly (12)

i. Six rings (5)

Remove

From screws (1)

From door (2)

Remove

j . Six screws (1)

Remove

k. Grommet (14)

CLEANING

WARNING

Dry cleaning solvent (P-D-680), used to clean parts is toxic and

flammable. Wear protective goggles and gloves and use only in a

well ventilated area. Avoid contact with skin, eyes, and clothes

and don't breathe vapors. Do not use near open flame or

excessive heat and don't smoke when using it. Failure to do so

could cause serious injury. If you become dizzy while using

cleaning solvent, get fresh air immediately, and get medical

attention. If contact with skin or clothes is made, flush with large

amounts of water. If contact with eyes is made, wash eyes with

water immediately, and obtain medical aid immediately.

2-150