Click here to make tpub.com your Home Page

Page Title: Hourmeter (cont).
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 10-3930-638-24&P
2-29. AUXILIARY PANEL MAINTENANCE (cont)
b. Hourmeter (cont).
REMARKS
ITEM
ACTION
LOCATION
STEP
CLEANING
WARNING
Dry cleaning solvent (P-D-680), used to clean parts is toxic and
flammable. Wear protective goggles and gloves and use only in a
well ventilated area. Avoid contact with skin, eyes, and clothes
and don't breathe vapors. Do not use near open flame or
excessive heat and don't smoke when using it. Failure to do so
could cause serious injury. If you become dizzy while using
cleaning solvent, get fresh air immediately, and get medical
attention. If contact with skin or clothes is made, flush with large
amounts of water. If contact with eyes is made. wash eyes with
water immediately, and obtain medical aid immediately.
Wire connectors and
Use cleaning solvent P-D-680 on
Clean
2
connectors and terminals only
hourmeter terminals
WARNING
Wear safety glasses when drying parts with compressed air.
Failure to do so could cause serious injury to eyes and possible
blindness. If you hurt your eyes or if a foreign object is blown
into your eyes, seek medical attention immediately.
Use cleaning solvent P-D-680.
Bracket (4) and all
Clean
3
Dry thoroughly with compressed air
hardware
INSPECTION
Replace if worn, or if threads damaged
All hardware
Inspect
4
Replace if insulation frayed, or if
Inspect
Positive wire and ground
5
conductors broken
wire
Replace if threads damaged, or if
Inspect
Hourmeter
6
receptacle terminals damaged
Replace hourmeter if bracket (4) cracked
7
Bracket (4)
Inspect
or damaged
INSTALLATION/REPLACEMENT
Inside left fender bolt hole
Position
8
Left hood support a. Ground wire and
plate, bottom
lead (2)
b. Cap screw (8), lock
Install and
washer (7) and nut (6)
tighten
On left side panel
c. Hourmeter (5)
Position
On hourmeter studs
Position
d. Bracket (4)
Until hourmeter is securely mounted
e. Two wing nuts (3)
Tighten both
evenly
Note tags for correct connection
f. Wire leads (1 and 2)
Push on
Use silicone rubber sealer
g. All leads and terminals Seal
2-143

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business