Starter Relay and-25 AMP Circuit Breaker (cont).

TM 10-3930-638-24&P

2-27. STARTING SYSTEM MAINTENANCE (cont)

b. Starter Relay and-25 AMP Circuit Breaker (cont).

REMARKS

ITEM

LOCATION

ACTION

STEP

REMOVAL

From relay center terminals

Tag and remove

Engine compart-

a. Nut (1), lock washer

(2) and wire

ment rear, left

b. Two nuts (3), lock

From relay end terminals

Tag and remove

side of vehicle

washers (4) and four

wires

c. Two cap screws (5),

Remove

Support relay (8) and mounting plate (15)

lock washers (6) and

flat washers (7)

Remove

From mounting plate (15)

d. Starter relay (8)

e. Two nuts (9), lock

Tag and remove

From circuit breaker terminals

washers (10) and

three wires

Remove

Support circuit breaker (14) and

f. Two nuts (11), lock

washers (12) and

mounting plate (15)

screws (13)

g. Circuit breaker (14)

Separate

and mounting

plate (15)

CLEANING

Wipe exterior with clean, dry cloth

Starter relay (8) and

Clean

circuit breaker (14)

WARNING

Dry cleaning solvent (P-D-680), used to clean parts is toxic and

flammable. Wear protective goggles and gloves and use only in a

well ventilated area. Avoid contact with skin, eyes, and clothes

and don't breathe vapors. Do not use near open flame or

excessive heat and don't smoke when using it. Failure to do so

could cause serious injury. If you become dizzy while using

cleaning solvent, get fresh air immediately, and get medical

attention. If contact with skin or clothes is made, flush with large

amounts of water. If contact with eyes is made, wash eyes with

water immediately, and obtain medical aid immediately.

Wire connectors and

Use cleaning solvent P-D-680 on

Clean

connectors and terminals only

terminals

WARNING

Wear safety glasses when drying parts with compressed air.

Failure to do so could cause serious injury to eyes and possible

blindness. If you hurt your eyes or if a foreign object is blown

into your eyes, seek medical attention immediately.

2-125