Accelerator/Throttle Control (cont). - TM-10-3930-638-24-P0106

TM 10-3930-638-24&P

2-15. FUEL SYSTEM MAINTENANCE (cont)

i. Accelerator/Throttle Control (cont).

ITEM

ACTION

STEP

LOCATION

REMARKS

INSTALLATION/REPLACEMENT (cont)

13 (cont)

h. Two washers

Install

(5), lock

washers (4),

and nuts (3)

i. Ball joint (2)

Install

On accelerator cable (8) then connect to

fuel injection pump throttle lever

j. Nut (1)

Install

adjustment

Engine com-

a. Nut(1)

Remove

b. Ball joint (2)

partment

From fuel injection pump throttle lever

Disconnect

c. Ball joint (2)

Adjust and

Adjust for minimum slack in accelerator

connect

cable by threading further onto ca-

ble (8); increase slack by threading out

of accelerator cable. Tighten nut (29)

NOTE

When connecting ball joint (2) to throttle lever be sure you

don't move throttle lever.

Connect to throttle lever; if all slack in

cable has been removed, reinstall nut

(1)

NOTE

If too much or not enough slack in accelerator cable, per-

form step 15.

a. Two nuts (26)

Operator's

Remove

compartment

and lock wash-

er (27)

b. Ball joint (28)

Disconnect

From accelerator pedal (40)

c. Ball joint (28)

Adjust and

Adjust for minimum slack in accelerator

connect

cable by threading further onto cable

(8); increase slack by threading out

of accelerator cable. Tighten nut (29)

NOTE

When connecting ball joint (28) to accelerator lever, be sure you

don't move throttle lever.

Connect to accelerator pedal and check

slack; if too much or too little slack,

repeat above adjustment. Reinstall

two nuts (26) and lock washer (27).

Repeat step 14 if necessary.

2-70