 |
|||
|
|
|||
|
Page Title:
Electric Fuel Pump and Lines (cont). |
|
||
| ||||||||||
|
|
 TM 10-3930-638-24&P
2-15. FUEL SYSTEM MAINTENANCE (cont)
b. Electric Fuel Pump and Lines (cont).
STEP
ITEM
LOCATION
ACTION
REMARKS
INSPECTION (cont)
6
Hose barbs (6 and 7)
Replace if cracked or threads damaged
Inspect
Inspect
All other parts
Replace if threads damaged
7
INSTALLATION/REPLACEMENT
Position
a. Electric fuel
Engine compart-
8
pump (12)
ment, right rear
Position
b. Two cap screws
(11)
Position
Tighten two nuts (8) securely
c. Two washers (10),
and
lock washers (9)
install
and nuts (8)
Install
d. Two hose barbs
(6 and 7)
Position
On hose (4)
e. Two hose clamps (3)
If necessary, make from bulk hose (FSCM
f. Fuel filter hose (4)
Connect
81343, P/N SAE30R3-14ID); cut to
3 0.12 inches long. Tighten two hose
clamps (3)
Position
On hose (2)
g. Two hose clamps (1)
Connect
If necessary, make from bulk hose (FSCM
h. Filter supply hose
81343, P/N SAE30R1-14ID); cut to
(2)
31 + 0.2 inches long. Tighten two hose
clamps (1).
i. Screw terminal (5)
Connect wire and Serial number 9150018 and below
tighten
j. Wire lead (5A)
Connect to wiring Serial number 9150019 and over
harness
Place ignition switch in ON position and
open bleed valve on top of secondary
fuel filter allowing air to bleed out of
both filters. When fuel, free of bubbles
starts to flow, close bleed valve and
wipe parts free of fuel, Turn ignition
switch off.
TESTING
a. Hose clamp (1)
9
Engine compart-
Loosen
At fuel filter head
b. Filter supply
Disconnect
ment, right rear
At fuel filter head; place end of hose into a
hose (2)
gallon container
Operator's com-
Ignition switch
Place in ON
10
partment
position
11
Engine compart-
a. Electric fuel
Listen for
slight buzz
ment
pump
b. Gallon container
Observe hose
Fuel should be pumped out of hose (2) into
(2)
container
Change 2 2-43
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals