Figure 5-21. Rear Power Steering valve,removal,disassembly, reassembly and installation

TM 10-3930-634-34

CAUTION

Do not move mode selector while installed.

Length of rod or tube should not exceed 3 3/4

g. Disconnect front and rear drag links. Adjust

inches.

front and rear wheels to aim straight ahead and to

f. Place selector in two-wheel steer and pass snug-fit-

have zero toe-in. Toe-in is adjusted by changing tie rod

ting, round rod or tube through aligning hole in inter-

setting. Wheel position is adjusted by using long pry

mediate steering arm, and, if necessary, adjust the 3-

bar wedged between axle hub and wheel rim. Consider-

position cylinder until the aligning hole in the inter-

able force is required as hydraulic fluid must be forced

mediate steering arm lines up with aligning hole in pit-

through the power steering system. Alignment is veri-

man arm. Leave the rod or tube installed.

Change 1

5-31