Figure 2-4. Truck stopping instructions

TM 10-3930-631-12

RELEASE FOOT FROM ACCELERATOR

DEPRESS SERVICE BRAKE PEDAL GRADUALLY TO BRING TRUCK TO A SAFE SMOOTH STOP.

MOVE TILT CONTROL LEVER FORWARD TO PLACE MAST IN A VERTICAL POSITION.

MOVE SIDE SHIFT CONTROL LEVER TO CENTER CARRIAGE

MOVE LIFT CONTROL LEVER FORWARD AND LOWER CARRIAGE AND FO RKS TO THE GROUND.

TURN KEY SWITCH TO THE LEFT TO "OFF" POSITION TO CUT OFF CONTROL CIRCUITS NOTE: TO

STOP ALL ELECTRICAL OPERATIONS IN AN EMERGENCY, DEPRESS EMERGENCY STOP SWITCH.

PARKING BRAKE IS APPLIED WHEN SEAT IS EVACUATED.

Figure 2-4. Truck stopping instructions.

b. The brake is automatically set when the

2-7. Moving the Truck

operator leaves the seat. A linkage connected to the

a. Refer to paragraph 2-4 and start the truck.

seat sets the brake when weight is removed.

b. Raise forks slightly to clear ground by pulling lift

control lever Fig. 2-1) to rear.

c. Place forward and reverse lever (fig. 2-1) in F

2-6. Operation of Equipment

for forward movement or R for reverse movement.

The following paragraphs and illustrations describe

d. Depress accelerator (fig. 2-1) to increase

truck operation under usual conditions.

motor speed and move truck. Control speed of travel

with pressure on accelerator.

2-5