Differences Among Models

TM 10-3930-627-12

Height (forks fully

(9) Instrument voltage regulator. The

raised) ..................................... 192 in.

instrument voltage regulator is a small voltage divider

Width ....................................... 63 in.

which reduces system voltage to six volts for instrument

Length (less forks) .................. 91 in.

power.

Vehicle weight ......................... 8034 Lb

1-6. Differences Among Models

Ground clearance.................... 3 in.

This manual covers the Baker Model FJF-040 Gasoline

Attachments ............................ Overhead guard and load

Powered fork lift truck, pneumatic tired. Trucks covered

safety rack

in this manual are those procured under contract DSA-

(3) Engine.

400-70-C-3557 only. There are no known differences

Type (Military Standard) Continental Model No. FS162

among trucks covered in this manual.

Number of cylinders ............... 4

1-7. Identification and Tabulated Data

a. Instruction Plates.

Max. oil pressure hot at

(1) HOIST-UP-DOWN plate at lift control

1800 rpm ................................. 30 to 40 psi

handle.

Min. oil pressure...................... 7 psi at idle

(2) TILT-OUT-IN plate at tilt control handle.

Firing order .............................. 1-3-4-2

(3) START plate at starter switch.

Oil Capacity:

(4) LIGHTS ON-OFF plate at light switch.

Crankcase .................. 31 qt

(5) IGN ON-OFF plate at ignition switch.

Filter ........................... 1 qt

(6)

Plate at rear face of mast top

Total ........................... 4 qt

CAUTION: DO NOT TOW OR PUSH THIS TRUCK.

Valve Clearance:

(7) Plate at right front, truck frame. Wheel

Intake .........................

0.014 in.

loading data, loaded and empty.

Exhaust ......................

0.014 in.

(8)

Plate at right front, truck frame.

Cooling system capacity ......... 11% qt

Shipping data, center of gravity location and lift point

(4) Fuel system.

ratings.

b. Identification Plates.

Carburetor:

Make .......................... Zenith

(1) Plate at right front, truck frame. Truck

identification, per MIL-P-514.

Type .......................... Updraft, single bore

Adjustments:

(2) Engine plate, side of crankcase, per

Idle mixture screw ...... 1 to 1.5 turns open

MIL-P-5 14.

(3)

Transmission plate, side of case.

Idle speed................... 450 to 500 engine rpm

Specifies make, model and serial number.

Fuel Pump:

c. Tabulated Data.

Pressure (static) ......... 1.5 to 2.25 psi

(1) General.

Capacity (minimum) ... 1 pt per min.

Rated Capacity ........................4000 Lb at 24 in. from

'Fuel tank capacity................... 12.7 gal.

heel of fork

Governor setting...................... 2600 engine rpm

(5) Transmission.

Lift Type ...................................Telescopic upright boom,

tiltable 3 deg forward,

Make ....................................... Baker

Type ........................................ Single-speed with forward

10 deg backward from

upright

and reverse constant

Lift Elevation (Max)..................144 in.

mesh, power-shifted by

Fork Data ................................4 in. wide prongs, 40 in.

selective engagement of

long. Adjustable from 9

clutches in oil

to 38 in.

Ratio ........................................ 1.19 to 1 reduction

Wheels ....................................4 drive wheels and 2

Input ........................................ From torque converter

steerable wheels

Output ..................................... Direct to drive axle ring

Tires ........................................Pneumatic, size 7.00 x 12

gear

(drive

axle),

and

Clutches .................................. 2 self-adjusting single

6.90/6.00 x 9 (steering

cork-faced disks

axle)

Fluid ........................................ OE 10

Tire pressure (all) ....................100 psi

Capacity .................................. 16 qt

Vehicle turning radius ..............90 in. min. outside turning

(Includes drive axle

and torque converters)

radius

(6) Drive axle.

Vehicle top speed ....................12 mph

Make ....................................... Rockwell-Standard

Maximum towed speed ...........2 mph

Note. Observe instruction plate details at rear face of

Reduction gearing .................. Double-reduction,

ring

mast top crossmember.

and pinion plus internal-

(2) Overall dimensions and weight.

to-sun gears

Height (forks fully

lowered)...................................91 in.

1-10