|
|
APPENDIX B
BASIC ISSUE ITEMS LIST
Section I. INTRODUCTION
B-1. Scope
Code
Explanation
This appendix lists items which accompany the forklift
requirements will be requisitioned, with
truck or are required for installation, operation, or
accompanying justification through normal
operator's maintenance.
supply channels.
G
Major assemblies that are procured with PEMA
B-2. General
funds for initial issue only as exchange
This Basic Issue Items List is divided into the following
assemblies at DSU and GSU level. These
sections:
assemblies will not be stocked above GS and
DS level or returned to depot supply level.
which accompany the forklift truck and are required by
(2) Maintenance code indicates the lowest
the operator/crew
for installation, operation, or
category of maintenance authorized to install the listed
maintenance.
item. The maintenance level code is:
b. Maintenance and Operating Supplies--Section
Code
Explanation
C
Operator / crew
required for initial operation.
(3) Recoverability code indicates whether
unserviceable items should be returned for recovery or
B-3. Explanation of Columns
salvage.
Items not coded are expendable.
The following provides an explanation of columns in the
Recoverability codes are:
tabular list of Basic Issue Items, section II.
a. Source, Maintenance, and Recoverability Codes
Code
Explanation
(SMR): (1) Source code indicates the source for the
R
Repair parts (assemblies and components)
listed item. Source codes are:
which are considered economically reparable
Code
Explanation
at direct and general support maintenance
P
Repair parts which are stocked in or supplied
levels. When the maintenance capability to
from the GSA/ DSA, or Army supply system
repair these items does not exist, they are
and authorized for use at indicated
normally disposed of at the GS level. When
maintenance categories.
supply considerations dictate, some of these
M
Repair parts which are not procured or stocked,
repair parts may be listed for automatic return
but are to be manufactured in indicated
to supply for depot level repair as set forth in
maintenance levels.
AR 710-50. When so listed, they will be
A
Assemblies which are not procured or stocked
replaced by supply on an exchange basis.
as such, but are made up of two or more
S
Repair parts and assemblies which are
units. Such component units carry individual
economically reparable at DSU and GSU
stock numbers and descriptions, are procured
activities and which normally are furnished by
and s stocked separately and can be
supply on an exchange basis. When items
assembled to form the required assembly at
are determined by a GSU to be
indicated
maintenance categories.
uneconomically reparable they will be
X
Parts and assemblies which are not procured or
evacuated to a depot for evaluation and
stocked and the mortality of which normally is
analysis before final disposition.
below that of the applicable end item or
T
High dollar value recoverable repair parts which
component. The failure of such part or
are subject to special handling and are issued
assembly should result in retirement of the
on an exchange basis. Such repair parts
end
item from the supply system.
normally are repaired or overhauled at depot
X1
Repair parts which are not procured or stocked.
maintenance activities.
The requirement for such items will be filled
U
Repair parts specifically selected for salvage by
by
use of the next higher assembly or
reclamation units because of precious metal
component.
content, critical materials, or high dollar value
X2
Repair parts which are not stocked. The
reusable casings or castings.
indicated maintenance category requiring
b. Federal Stock Number. This column indicates
such
repair parts will attempt to obtain them
the Federal stock number assigned to the item and will
through
cannibalization. Where such
be used for requisitioning purposes.
repair parts are not
obtainable
through
cannibalization,
B-1
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |