FLOOR PLATE INSTALLATION.

TM 10-3930-623-12

2. Remove the two screws at the front corners of

6-23. DELETED

the floor plate, and pull accelerator pedal free of the

throttle linkage. The pedal has a molded rubber socket

mating with a ball formed on the end of the linkage rod

6-24. DELETED

for a friction fit.

3. Raise the rear edge of the floor plate, and draw

it clear of the brake pedals and steering gear.

6-20. FLOOR PLATE INSTALLATION.

1. Lay floor plate in position on truck frame, with

throttle linkage in position for connection to accelerator

pedal.

2. Install attaching parts previously removed and

press ball at end of throttle linkage into socket in

underside of accelerator pedal. Wetting socket will

make installation of ball easier, but do not use oil.

6-21. DELETED

6-22. DELETED

6-25. TILT CYLINDER ASSEMBLIES.

6-26. REMOVAL.

WARNING

Before disconnecting tilt cylinders,

tilt uprights back and tie in place, to

prevent it falling forward while tilt

cylinders are disconnected.

1. Remove truck floor plate for access to tilt

cylinders. Disconnect both hoses at each tilt cylinder.

2. Remove lock screws (see figure 6-2) and pins

attaching tilt cylinders to outer uprights and the truck

frame. Remove tilt cylinders from truck.

6-27. INSTALLATION.

1. Attach rear end of each tilt cylinder to truck

frame with pins and lock screws removed previously.

Reconnect tilt cylinder hoses.

2. Operate tilt control to bring plungers fully into tilt

cylinders as far as they will go. Check that mounting

pins will enter both plunger yoke holes and mounting

holes on uprights at the same time without extending

one plunger

6-3