TABLE 2-1. TABLE OF SPECIFICATIONS

TABLE 2-1. TABLE OF SPECIFICATIONS (Cont'd)

3. ENGINE LIMITS AND CLEARANCE DATA

4. FUEL SYSTEM

Valve seat diameter - exhaust ...........................1-1/4 in.

Make ....................................................Marvel-Schebler

Valve seat diameter - intake ..............................1-3/8 in.

Part No .............................................................. TSX887

Face of valve seat - exhaust ..............0.09375/0.125 in.

Type ............................................... Updraft, single bore

Face of valve seat - intake .................0.09375/0.125 in.

Adjustments

Valve stem clearance

Idle mixture screw...................... 1 to 1.5 turns open

in guide, standard ..........................0.002/0.0025 in.

Idle speed screw.................. 450 to 500 engine rpm

Valve tappet clearance - intake ........................0.007 in.

Fuel tank capacity ...................................... 10.4 gallons

Valve tappet clearance - exhaust .....................0.010 in.

Governor setting.................................. 2400 engine rpm

Tappet clearance in guide ..................0.00075/0.001 in.

5. TRANSMISSION

Idler bearing clearance .......................0.00075/0.001 in.

Make .................................................................... Baker

Camshaft bearing clearance ..............0.0015/0.0025 in.

Part no............................................................. A9020R1

Water pump shaft clearance ..............0.0015/0.0025 in.

Type ..................................... Single-speed with forward

Crankshaft thrust clearance ...................0.002/0.004 in.

and reverse constant mesh

power-shifted by selective

Connecting rod side clearance ...............0.005/0.010 in.

engagement of clutches in oil

Flywheel housing clearance,

Ratio ................................................. 1.19 to 1 reduction

on chamfer .......................................0.012/0.025 in.

Input ........................................... From torque converter

Water pump shaft end thrust..................0.002/0.003 in.

Output ............................... Direct to drive axle ring gear

Water pump gear

back lash to idler gear......................0.002/0.004 in.

Clutches ........... 2 self-adjusting single cork-faced disks

Camshaft gear

Fluid .....................................................................OE 10

back lash to crankshaft ...................0.000/0.002 -in.

Capacity ................................................. 10 qt (includes

Idler gear back lash to camshaft. .......0.0005/0.0015 in.

torque converter)

Oil pump gear

6. DRIVE AXLE

back lash to camshaft ......................0.008/0.010 in.

Make ................................................Rockwell-Standard

Piston ring gap........................................0.015/0.020 in.

Part No. .................................................... TA199FHX34

Piston ring land clearance

Reduction gearing ..... Double-reduction, ring and pinion

Top, second and third grooves ......0.0015/0.003 in.

plus internal-to-sun gears

Fourth groove (oil)........................0.0005/0.0025 in.

Reduction overall ............................................... 15.05:1

Piston pin clearance ...........................0.0001/0.0002 in.

Capacity ................................................................. 11 pt

Piston clearance ...................................0.0025/0.003 in.

Outside wheel track......................................... 54-7/8 in.

Inside wheel track ........................................... 36-1/8 in.