Transmission - continued

TM 10-3930-621-34

(b) Remove bearing retaining ring (6), depress

retaining ring on bearing, and slide bearing.(5)

(a)Remove retainer cap (38) by removing attaching

from forward shaft (4).

bolts (40) and lock washers (39). Discard gasket

(37).

(b) Mark position of pin (41) holding shaft in retainer

forward gear retaining ring (3).

(d) Using a rawhide hammer and holding forward

cap (38) to insure proper assembly and remove

gear 12) in place, tap forward shaft (4) out

pin.

through bearing retainer opening. Remove

Note. Idler gear assembly consists of two needle

forward gear (2) from case.

(8) Remove reverse gear and shaft as follows:

bearings (35) and a gear (34).

(a) Match mark disc assembly retainer (11, fig. 6-7)

(10) Remove the output gear and shaft as follows (fig.

and remove retainer attaching lock washers

(13) and bolts (12) and retainer.

(a) Remove output flange (11) and oil seal (12).

(b)Remove sealing rings (14) from retainer (11).

(b) Remove retainer (15) by removing attaching bolts

(c)Remove needle bearings (42 and 43, fig. 6-61

(13) and lock washers (14). Discard gasket (16).

from reverse shaft (44).

(c)While holding output gear (19) in gear box,

(d) Remove retaining ring (3) and reverse gear (2)

remove output shaft (18).

(d) Remove output gear (19) and both ball bearings

from reverse shaft (44).

(e) Tap shaft (44) out disc and drum assembly side

(17).

of transmission and remove bearing retaining

(e) Remove expansion plug (20).

ring (3).

(11) Remove plug (25, fig. 6-6), spring (24), and

(f)Remove bearing (26) with retaining ring (27).

screen (23) from bottom portion of transmission

(9) Remove idler gear and shaft as follows (fig.

case (321.

6-6