Section II. DESCRIPTION AND DATA - TM-10-3930-618-200034

1-2. Forms and Records

mitted on DA Form 2028 (Recommended Changes to

Publications) and forwarded direct to (Commanding

a. DA Forms and records used for equipment main-

General, U.S. Army Mobility Equipment Command,

tenance will be only those prescribed in TM 38-750.

ATTN: AMSME-MPP, 4300 Goodfellow Boulevard

b. The reporting of errors, omissions, and recom-

St. Louis, Mo. 63120.

mendations for improving this publication by the

individual user is encouraged. Reports should be sub-

Section II. DESCRIPTION AND DATA

1-3. Description

(2) Capacities.

16 Qt

Cooling system

Army Model MHE-213 (Allis-Chalmers Model FP60-

3 Qt

Drive axle differential

24PS) trucks are non-tactical forklift trucks designed

Planetary

gear

housing

7 Qt

for use in a warehouse or on hard surface pavement.

Engine crankcase (with filter)

14.5 Gal

Fuel tank

The truck (fig. 1-1 and 1-2) can be used to load,

Hydraulic system:

transport and unload, and stack loads weighing as

Brake

master

cylinder

much as 6000 lbs. at a load center of 24 inches and ran

Lines

1 Pt

lilt the load to a height of 168 inches. (The load center

28 Qt

Tank (lift hydraulic system)

11 Qt

is measured from the heel of the forks.) The truck is

Transmission (with filter)

(3) Hydraulic system (steering)

2.5 to 3.2 g.p.m. @ 1200 psi

Flow regulator setting

engine and is equipped with power assist brakes, power

(4) Hydraulic system (main)

steering, and single speed automatic transmission.

2000 psi @ 1800 RPM

Proper setting

NOTE

(5) Critical torque valves.

Throughout this manual, the use of the terms right, left,

110 ft-lb

Cylinder head bolts

front, and rear indicates directions from the viewpoint of

Spark plugs

15-20 ft-lb

the operator sitting in the seat of the truck.

(6) Battery.

Voltage

1-4. Identification and Tabulated Data

Terminal

grounded

a. Identification. The truck has one identification

(7) Valves.

Intake valve clearance (cold)

0.012 in.

plate. It is located in the center of the instrument panel.

Intake

clearance

(hot)

(engine

It contains information pertaining to the manu-

coolant at normal operating

facturer, model. nomenclature, contract number, seri-

0.010 in.

temperature)

al number, registration number, Federal Stock Sum-

Exhaust valve clearance (cold)

0.014 in.

Exhaust valve clearance (hot) (engine

ber, engine serial number, capacity, and date shipped.

0.012 in.

normal

operating

temperature)

b. Tabulated Data.

(8) Spark plugs

Manufacturer

Allis-Chalmers

14 mm

Size

Model

FP60-24PS

Point gap

0.025 in.

Army Model

MHE-213

(9) Distributor

(1)

Engine

0.022 in.

Point gap

Allis-Chalmers

Make

6mb-230

Model

Governed speed

2200 RPM

Firing

order

1-5-3-6-2-4

500 RPM

Idle speed

1-4