Figure 3-19B - Continued

TM 10-3930-611-35

Figure 3-19B - Continued

(3) Refer to figure 3-23 and remove the

to approximately 14 3/4 inch diameter. Replace tapered

steering axle.

roller bearings if excessive pittings in race are visible.

b. Disassembly. Refer to figure 3-24 and

Replace king pin needle bearings if king pin has been

removed.

Replace spindles if out-of-straightness

disassemble the steering axle assembly.

c. Cleaning, Inspection and Repair.

exceeds 1/16 inch. Replace oil seal if deterioration is

evident.

(1) Clean all parts with dry cleaning

d. Reassembly. Refer to figure 3-24 and

solvent (Federal Specification P-D-680).

reassemble the steering axle assembly.

(2) Inspect wheel bearings for pitting and

e. Installation.

spindles for out-of-straightness. Inspect oil seal for

deterioration and tires for wear. Inspect all parts for

(1) Refer to figure 3-23 and install the

breaks, cracks, loose or missing mounting hardware, or

steering axle.

other defects.

(2) Install the pivot block mounting bolts.

(3) Tighten or replace loose or missing

(3) Connect the steering booster (para 3-

hardware.

Replace tires if rubber is worn down

3-25