|
| |
- DEPARTMENT OF THE ARMY
TECHNICAL MANUAL
- SAFETY PRECAUTIONS
- Direct Support, General
Support, and Depot Maintenance Manual
- APPENDIX REFERENCES
- TABLE OF CONTENTS
- CHAPTER 1 INTRODUCTION
- Table 1-1. Applicable Wear
Limits and Clearances
- CHAPTER 2 GENERAL
MAINTENANCE INSTRUCTIONS
- Figure 2-1. Schematic
diagram.
- Figure 2-2. Wiring diagram.
- Table 2-1. Troubleshooting
- Table 2-1. Troubleshooting -
CONT
- Table 2-1. Troubleshooting-
CONT
- Table 2-1. Troubleshooting -
CONT
- Table 2-1. Troubleshooting -
CONT
- Test of Accelerating Control
Potentiometer
- Test of SCR's (1 REC, 2 REC,
5 REC)
- Section III. RADIO
INTERFERENCE SUPPRESSION
- Section IV. REMOVAL AND
INSTALLATION OF MAJOR COMPONENTS AND AUXILIARIES
- Control Valve
- Hydraulic Oil Tank
- Installation.
- Hydraulic Pump
- Figure 2-12. Hydraulic pump
motor, drive axle and steering axle.
- Hydraulic Pump Motor
- Steering Axle
- Fuse Holder
- Pump Relay
- SCR Assembly
- CHAPTER 3 REPAIR
INSTRUCTIONS
- Section II. OVERHAUL OF
DRIVE AXLE AND ADAPTER
- Figure 3-1. Adapter,
exploded view.
- Figure 3-2. Drive axle,
exploded view.
- Cleaning Disassembled Parts
of Adapter and Drive Axle
- Reassembly of Drive Axle
- Figure 3-3. Ring and pinion
gear tooth contact indications.
- Section III. OVERHAUL OF
STEERING AXLE
- Section IV. REMOVAL AND
REPAIR OF BRAKE SYSTEMS
- Figure 3-5. Motor brake
shoes and drum.
- Reinstallation of Motor
Brakeshoes and Drum
- Repair of Wheel. Cylinders
- Repair of Master Cylinder
- Section VI. STEERING GEAR
OVERHAUL
- Figure 3-9. Steering gear,
exploded view.
- Inspecting Parts of Steering
Gear
- Section VII. REPAIR OF
HYDRAULIC PUMP
- Section VIII. REPAIR OF
HYDRAULIC DIRECTION CONTROL VALVE
- Cleaning Parts of Control
Valve
- Repair and Replacement of
Control Valve Parts
- Reassembly of Tilt Cylinder
- Section X. REPAIR OF HOIST
CYLINDER
- Disassembly of Hoist
Cylinder
- Section XI. REPAIR AND
OVERHAUL OF MAST ASSEMBLY
- Figure 3-14. Mast assembly,
exploded view.
- Reassembly of Mast Assembly
- Cleaning Disassembled Parts
of Travel Motor
- Reassembly and Testing
Travel Motor (fig. 3-
- Installation of Travel Motor
- Section XIII. OVERHAUL AND
REPAIR OF PUMP MOTOR
- Cleaning Disassembled Parts
of Pump Motor
- Figure 3-17. Pump motor,
exploded view.
- Figure 3-18. Pump motor
brushholder and field connections.
- Figure 3-19. Setup for bench
testing pump motor.
- Section XIV. REPAIR OF
ACCELERATOR CONTROLLER
- Figure 3-20. Accelerator
controller, exploded view.
- Section XV. REPAIR OF
DIRECTIONAL CONTROL SWITCH
- Disassembly of Directional
Control Switch
- Section XVI. REPAIR OF PUMP
AND MASTER SWITCH RELAYS
- Cleaning Disassembled Parts
of Pump Relay and Master Switch Relay
- Section XVII. REPAIR OF
FORWARD AND REVERSE RELAY
- Cleaning Disassembled Parts
of Forward and Reverse Relay
- Section XVIII. REPAIR OF
ACCELERATOR RELAY
- Figure 3-24. Accelerator
relay, exploded view.
- Cleaning Disassembled Parts
of Accelerator Relay
- APPENDIX A REFERENCES
- INDEX
- INDEX- CONT
- INDEX- CONT
- The Metric System and
Equivalents
- BLANK PAGE
- By Order of the Secretary of
the Army:
- TM-10-3930-609-35
- BLANK PAGE
- RECOMMENDED CHANGE TO
EQUIPMENT TECHNICAL PUBLICATION
- By Order of the Secretary of
the Army:
|
|
Click
here for thousands of PDF manuals