LUBRICATION ORDER -707990001

LUBRICATION ORDER

LO 10-3930-659-12

8 November 1993

TRUCK, FORKLIFT: ADVERSE TERRAIN,

10,000 LB CAPACITY, M544E

(NSN 3930-01-301-8250)

References: TM 10-3930-659-10 and TM 10-3930-659-20

REPORTING OF ERRORS AND RECOMMENDING IMPROVEMENTS

You can help improve this manual. If you find any mistakes or if you know of a way to improve the

procedures, please let us know. Mail your letter, DA Form 2028 (Recommended Changes to Publications and

Blank Forms), or DA Form 2028-2, located in the back of this manual, directly to: Commander, U.S. Army

Tank-Automotive Command, ATTN: AMSTA-MB, Warren, MI 48397-5000. A reply will be furnished to you.

This LO is for Crew/Operator (C) or Unit (O)

area. Avoid contact with skin, eyes,

Maintenance. Lubrication intervals (on-condition or

and clothes, and DO NOT breathe

hard time) are based on normal operation. Lube

vapors. DO NOT use near open

more during constant use and less during inactive

flame or excessive heat.

The

periods.

Use correct grade of lubricant for

solvent's flash point is 100F-138F

seasonal temperature expected.

(38 C-59C). If you become dizzy

while using cleaning solvent,

AOAP sampling intervals for the engine and

immediately get fresh air and

transmission are 50 hours of operation or 90 days,

medical help. If solvent contacts

whichever comes first. Hydraulic system sampling

eyes, immediately wash your eyes

is annually as prescribed by DA Pam 738-750. If

and get medical aid.

AOAP laboratory support is not available, HARD

Always install the frame locking bar

TIME INTERVALS APPLY

before working In the frame hinge

pivot area (see TM 10-3930-659-10).

Engine, transmission, and hydraulic system oil

Failure to follow this warning could

filters shall be changed when:

cause injury or death to personnel.

a. They are known to be contaminated, or

clogged;

Clean all fittings and area around lubrication points

b. Service is recommend by AOAP

with dry cleaning solvent or equivalent before

laboratory analysis; or

lubricating equipment. After lubrication, wipe off

c. At prescribed hard time interval.

excess oil or grease to prevent accumulation of

foreign matter.

On pictures, a dashed line (- - -) means lube points

on both sides.

Before you start your lube service:

ALWAYS

WARNING

Clean grease fittings before lubricating.

Dry cleaning solvent, P-D-680, is

Use the Lubrication Order as your

toxic and flammable. Always wear

guide.

protective goggles and gloves, and

NEVER

use only in a well-ventilated

Use wrong type/grade grease.

Use too much lubricant.

Approved for public release; distribution is unlimited.

Card 1 of 15

TA702958