EXPECTED TEMPERATURE - LO-10-3930-638-120004

1. TRANSMISSION. Drain only when oil is hot. After

Copy of this lubrication order will remain with the

draining oil, remove screen assembly and clean using

vehicle at all times. Instructions contained herein are

mandatory and supersede all conflicting lubrication

cleaning solvent. Reinstall screen assembly using new

gasket, tighten to 10-15 pounds foot. Remove and clean

instructions dated prior to the date of this lubrication

tansmission breather using cleaning solvent. Tighten

order.

new oil filter to 20-25 pounds foot. Check oil level with

engine at idle speed and transmission oil warm.

BY ORDER OF THE

2. HYDRAULIC RESERVOIR. Check level daily and

SECRETARY OF THE ARMY

add OE as necessary. Clean area around filler cap

thoroughly before removing. Drain only when oil is hot.

Clean suction screen and breather at each oil change.

3. ENGINE CRANKCASE. Drain only when oil is hot.

CARL E. VUONO

Refill to FULL mark on dipstick. Operate engine for a

General, United States Army

few minutes and recheck level. Add OE if necessary.

Replace oil filter at each oil change.

Chief of Staff

4. DIFFERENTIAL (FRONT AND REAR). Drive vehicle

for 10 minutes to warm lubricant. Clean area around fill

and drain plugs before removing. After draining, install

OFFICIAL:

drain plug and fill to fill plug opening with GO then

PATRICIA P. HICKERSON

install fill plug.

Colonel, United States Army

5. PARKING BRAKE HANDLE. Oil can point. BLOCK

The Adjutant General

WHEELS. Release brake and apply two drops on each

side of weldment.

DISTRIBUTION: To be distributed in accordance with DA Form 12-25-E. Block 2914. Operator, Unit maintenance requirements for

LO 10-3930-638-12.

CARD 4 OF 4

PIN: 031460-000