FOR OPERATION OF EQUIPMENT IN PROTRACTED COLD TEMPERATURES BELOW-15F (-26).

The following Is a list of

8. LUBRICANTS.

NOTES:

l u b r i c a n t s w i t h m i l i t a r y s y m b o l s and applicable

1. FOR OPERATION OF EQUIPMENT IN

specification numbers.

PROTRACTED COLD TEMPERATURES BELOW-15F

(-26).

Remove lubricants prescribed in Key for

OE/HDO

MIL-L-2104

temperatures above -15F (-26C). Relubricate with

MIL-L-2105

lubricants specified in Key for temperatures below -15F

GAA

MIL-G-10924

(-26C). If OEA lubricant is required to meet the

MIL-L-46167

OEA

temperature ranges prescribed in the Key, OEA lubricant

BFS

MIL-B-46176

IS to be used in place of OE/HDO-10 lubricant for all

GMD

MIL-G-21164

temperature ranges where OE/HDO-10 is specified in

(SD), Type II

P-D-680

the Key.

2. OIL CAN POINTS. Each 250 hours, lubricate

control linkage, pins and clevises, and all exposed

adjusting threads exposed with OE/HDO.

3. WHEEL BEARINGS. Each 1000 hours, remove

wheels, clean and Inspect all parts, replace damaged or

worn parts, repack bearings, and assemble.

Copy of this Lubrication Order will remain with the

4. BULL GEARS. Each 1000 hours, remove

equipment at all times, instructions contained herein are

wheels, clean, inspect and coat pinion and bull gear.

mandatory.

5. DIFFERENTIAL. Each 250 hours check level.

By order of the Secretary of the Army:

Change gear lubricant only when required by

maintenance repair action, contamination by water, or

After refill, operate for five

other foreign material.

JOHN A. WICKHAM, JR.

minutes, check for leaks and bring oil level to fill and

General, United States Army

level plug opening.

Chief of Staff

OFFICIAL:

6. HYDRAULIC RESERVOIR. Each 50 hours check oil

level. Each 1000 hours drain reservoir. Remove filter

ROBERT M. JOYCE

element, clean filter shell and Install new filter element.

Major General, United States Army

After replacement, refill reservoir and operate lift for 5

The Adjutant General

minutes, check for leaks, check oil level and bring to

"FULL" mark.

DISTRIBUTION:

To be distributed in accordance with

7. HYDRAULIC OIL FILTER. Each 250 hours, remove

DA Form 12-25A, Operator and Organizational

element, clean filter shell and Install new element. After

Maintenance requirements for Warehouse Equipment.

replacement, operate lift for 5 minutes, check for leaks,

check level and bring to "FULL" mark.

TA 221845

L0 10-393-00028&12 *US GOVERNMENT PRINTING OFFICE: 1984-42)-903/277

CARD 4 OF 4