FOR OPERATION OF EQUIPMENT PROTRACTED COLD TEMPERATURES BELOW 150F (-260C)

worn parts, repack bearings, and assemble.

NOTES:

FOR

OPERATION

EQUIPMENT

8. HYDRAULIC OIL RESERVOIR. Each 1000 hours

PROTRACTED COLD TEMPERATURES BELOW -

drain reservoir. Drain when lubricant is warm. Clean and

150F (-260C). Remove lubricants prescribed in Key for

replace strainer. Fill reservoir, operate hydraulic controls,

temperatures above -150F (-260C). Relubricate with

check for leaks, check oil level and bring to "FULL" mark.

lubricants specified in Key for temperatures below -150F

Check oil level with forks lowered and uprights tilted

(-260C). If OEA lubricant is required to meet the

back.

temperature ranges prescribed in the Key, OEA lubricant

is to be used in place of OE/HDO-10 lubricant for all

9. HYDRAULIC OIL FILTER. Each 500 hours, remove

temperature ranges where OE/HDO-10 is specified in the

element, clean filter shell and install new element. After

Key.

replacement, operate hydraulic system for 5 minutes,

check for leaks, check level and bring to "FULL" mark.

2. OIL CAN POINTS. Each 250 hours, lubricate brake

and hand brake linkage, accelerator pivot points, and all

10. LUBRICANTS. The following is a list of lubricants

exposed adjustable threads with OE/HDO.

with military symbols and applicable specification

numbers.

3. ENGINE OIL LEVEL HOT OR COLD CHECK. Cold

engine, oil level should be at high mark on dipstick. Hot

OE/HDO

MIL-L-2104

engine, oil level must be between high and low marks on

GAA

MIL-G-10924

dipstick (allow to set 5 minutes before checking).

OEA

MIL-L-46167

BFS

MIL-B-46176

4. ENGINE. Oil is to be changed each 250 hours. Drain

(SD), Type II

P-D-680

when lubricant is warm.

Copy of this Lubrication Order will remain with the

5. ENGINE OIL FILTER. Each 250 hours, remove filter

equipment at all times, instructions contained herein are

element, clean housing and install new filter element.

mandatory.

After installing new filter element, fill crankcase, operate

engine for 5 minutes, check housing for leaks, check

By order of the Secretary of the Army:

crankcase oil level and bring to "FULL" mark.

JOHN A. WICKHAM, JR.

General, United States Army

6. TRANSMISSION, CONVERTER AND DRIVE AXLE.

Chief of Staff

Check level each 10 hours with engine running at idling

OFFICIAL:

speed, oil at operating temperature and transmission in

ROBERT M. JOYCE

neutral. Maintain oil level at "FULL" mark. Change oil

Major General, United States Army

each 1000 hours. Drain when lubricant is warm. Fill

The Adjutant General

transmission to low mark. Run engine at idle speed to fill

DISTRIBUTION:

converter and lines. With engine running at idle speed, oil

To be distributed in accordance with DA

at operating temperature and transmission in neutral, add

Form 12-25A, Operator and Organizational

oil to bring oil level to "FULL" mark. Operate for 5

maintenance requirements for Fork Lift

minutes and check for leaks.

Trucks.

7. WHEEL BEARINGS. Each 1000 hours, remove front

wheels, clean and inspect all parts, replace damaged or

TA 220566

LO 10-3930-627-12

CARD 6 OF 6