HYDRAULIC RESERVOIR LEVEL

LO 10-3930-623-12

NOTES - CONTINUED:

3. HYDRAULIC RESERVOIR LEVEL. Each 50 hours

11. LUBRICANTS. The following is a list of lubricants

check level.

Maintain level to "FULL" mark with

with military symbols and applicable specification

OE/HDO.

Check oil level with forks lowered and

numbers.

uprights tilted back.

OE/HDO

MIL-L-2104

4. HYDRAULIC RESERVOIR. Each 500 hours remove

GAA

MIL-G-10924

breather cap, clean with approved dry cleaning solvent,

OEA

MIL-L-46167

and re-oil. Each 1000 hours change oil and clean

BFS

MIL-B-46176

strainer. After refill operate hydraulic system for 5

(SD), Type II

P-D-680

minutes, check for leaks, check oil level and bring to

"FULL" mark.

5. HYDRAULIC OIL FILTER. Each 500 hours, remove

element, clean filter shell and install new element. After

replacement, operate hydraulic system for 5 minutes,

check for leaks, check level and bring to "FULL" mark.

6. WHEEL BEARINGS. Each 1000 hours, remove dual

wheels, clean and inspect all parts, replace worn or

damaged parts, repack bearings, and assemble.

7. ENGINE OIL LEVEL HOT OR COLD CHECK. Cold

engine, oil level should be at high mark on dipstick. Hot

engine, oil level must be between high and low marks on

Copy of this Lubrication Order will remain with the

dipstick (allow to set 5 minutes before checking).

equipment at all times, instructions contained herein are

mandatory.

8. ENGINE CRANKCASE. Each 250 hours change

oil. Drain when oil is warm.

By order of the Secretary of the Army:

9. ENGINE OIL FILTER. Each 250 hours, remove filter

JOHN A. WICKHAM, JR.

element, clean housing and install new filter element.

General, United States Army

After installing new filter element, fill crankcase, operate

Chief of Staff

engine for 5 minutes, check housing for leaks, check

crankcase oil level and bring to "FULL" mark.

OFFICIAL:

10.

TRANSMISSION, CONVERTER AND DRIVE

ROBERT M. JOYCE

AXLE. Check oil level each 10 hours with engine

Major General, United States Army

running at idle speed, oil at operating temperature and

The Adjutant General

transmission in neutral. Maintain oil level to "FULL"

mark. Each 1000 hours change oil. Fill transmission to

DISTRIBUTION:

low mark. Run engine at idle speed to fill converter and

lines. Add oil to low mark. Operate for 5 minutes, check

To be distributed in accordance with DA Form 12-25A,

for leaks, check level and bring to "FULL" mark.

Operator

and

Organizational

maintenance

requirements for Fork Lift Trucks.

TA 220176

U.S. GOVERNMENT PRINTING OFFICE: 1984 O-754-600

CARD 6 OF 6