HYDRAULIC RESERVOIR AND FILTER

LO 10-3930-620-12

NOTES - CONTINUED:

parts, replace damaged or word parts, repack bearings, and assemble.

4. HYDRAULIC RESERVOIR AND FILTER Refer to TM 10-3930-620-12 for initial filter change interval. Each 50

hours check level. Maintain oil level at "FULL" mark. Each 1000 hours drain reservoir, replace filter element, clean

suction line screen, reinstall drain plug and fill reservoir. Operate lift for 5 minutes, check for leaks, check oil level

and bring to "FULL" mark.

5. HYDRAULIC OIL FILTER. Each 250 hours, remove filter element, filter shell housing and install new element. After

replacement, operate lift for 5 minutes, check for leaks, check oil level and bring to "FULL" mark.

6. DRIVE AXLE. Each 250 hours check level. Change gear lubricant only when required by maintenance repair action,

contamination by water, or other foreign material. After refill, operate for five minutes, check for leaks and bring oil

level to level plug opening.

Copy of this Lubrication Order will remain with the

7. LUBRICANTS. The following is a list of lubricants

equipment at all times, instructions contained herein are

with military symbols and applicable specification

mandatory

numbers.

OE/HDO

MIL-L-2104

By order of the Secretary of the Army:

MIL-L-2105

GAA

MIL-G-10924

JOHN A. WICKHAM, JR.

OEA

MIL-L-46167

General, United States Army

BFS

MIL-B-46176

Chief of Staff

(SD), Type II

P-D-680

OFFICIAL:

ROBERT M. JOYCE

Major General, United States Army

The Adjutant General

DISTRIBUTION:

To be distributed in accordance with DA Form 12-25A,operational Maintenance requirements for Warehouse Equipment.

U.S. Government Printing Office: 1984-420-903/260

Card 5 of 5