FOR OPERATION OFEQUIPMENT PROTRACTED COLD TEMPERATURES BELOW -15F (-260C).

9. TRANSMISSION AND TORQUE CONVERTER.

NOTES

Check oil level each 50 hours with engine running at idle

FOR

OPERATION

EQUIPMENT

speed, oil at operating temperature and transmission in

PROTRACTED COLD TEMPERATURES BELOW -15F

neutral. Maintain oil level to "FULL" mark. Change oil

(-260C).

Remove lubricants prescribed in Key for

each 1000 hours. Access to converter drain plug is

temperatures above -150F (-260C). Relubricate with

gained through timing cover opening on engine flywheel

lubricants specified in Key for temperatures below -150F

housing. Rotate until drain plug is in opening, remove

(-260C). If OEA lubricant is required to meet the

plug and rotate flywheel until plug opening is aligned with

temperature ranges prescribed in the Key, OEA lubricant

opening at bottom of flywheel housing. Fill transmission

is to be used in place of OE/HDO-10 lubricant for all

to low mark. Run engine at idle speed to fill converter

temperature ranges where OE/HDO-10 is specified in

and lines. With engine running at idle speed, oil at

the Key.

operating temperature and transmission in neutral, add

oil to bring oil Ievel to "FULL" mark. Operate for 5

OIL CAN POINTS. Each 250 hours, lubricate shift

minutes and check for leaks.

and accelerator linkage, control valve linkage, brake

linkage and all exposed adjusting threads with OE/HDO.

10. TRANSMISSION OIL FILTER. Each 1000 hours

remove filter element, clean filter housing, install new

ENGINE OIL LEVEL HOT OR COLD CHECK.

filter element and seal. Fill transmission to low mark.

Cold engine, oil level should be at high level mark on

With engine running at idle speed, oil at operating

dipstick. Hot engine, oil level must be between high and

temperature and transmission in neutral, add oil to bring

low marks on dipstick (allow to set 5 minutes before

oil level to "FULL" mark. Operate for 5 minutes and

checking).

check filter housing for leaks.

ENGINE. Oil is to be changed each 250 hours.

11. COMPATIBILITY OF HYDRAULIC OIL. Spectrum

Drain when lubricant is warm.

analysis of hydraulic oil and OE/HDO 10 indicates these

oils are compatible and can be intermixed without

ENGINE OIL FILTER. Each 250 hours, remove

concealed harmful effect.

filter element, clean housing and install new filter

element.

After installing new filter element, fill

12. HYDRAULIC OIL FILTER.

Each 1000 hours,

crankcase, operate engine for 5 minutes, check housing

remove element, clean filter housing and install new

for leaks, check crankcase oil level and bring to "FULL"

element. After replacement, operate hydraulic system

mark.

for 5 minutes, check for leaks, check level and bring to

"FULL" mark.

AIR CLEANER. Each 50 hours disassemble entire

unit, clean, assemble, re-oil to level mark.

13. PLANETARY GEARS AND WHEEL BEARINGS.

Check oil level each 50 hours. TO check level, turn drive

DISTRIBUTOR. Each 250 hours, lubricate rotor

wheels until oil plugs are in position 90 degrees from

wick with 3 or 4 drops of OE/HDO 10. Apply very light

bottom dead center. Remove plugs, check oil level and

coat of GAA to breaker cam.

add oil as necessary.

WHEEL BEARINGS. Each 1000 hours, remove

wheels, clean and inspect all parts, replace damaged or

worn parts, repack bearings, and assemble.

TA 219928

CARD 5 OF 6