Remove gland (2) from rod (1).
Remove two preformed packings (4
and 11) and one backup ring (12)
from gland (2). Discard preformed
Do not nick or scratch seal groove of
gland during removal of seal and
rod wiper. Failure to follow this
precaution will cause part damage.
Note direction of lip of seal is facing
to aid in installation.
(m) Remove seal (13) and rod wiper (14)
from inside of gland (2).
b. Cleaning. See Cleaning Instructions (Para 2-12).
c. Inspection. See Inspection Instructions (Para 2-14).
Wipe all sealing surfaces on cylinder clean and dry. Apply film of clean hydraulic oil to all
seals as they are installed.
Assemble cylinder parts (1 through 14).
Install seal (13) and rod wiper (14) in inner diameter of gland (2). Ensure that seal is
positioned in same direction as was noted before removal.
Install backup ring (12) and two preformed packings (4 and 11) on outer diameter of gland