Lubricate inner diameter of inner
gland (2), seal (12) and rod
wiper (13) with clean hydraulic oil.
Slide inner gland (2) onto rod (1).
· Drycleaning Solvent (P-D-680) is
TOXIC and flammable. Wear
protective goggles and gloves; use
only in a well-ventilated area;
avoid contact with skin, eyes, and
clothes; and do not breathe
vapors. Keep away from heat or
flame. Never smoke when using
solvent; the flashpoint for type I
drycleaning solvent is 100°F
(38°C), type II is 138°F (59°C),
and type III is 200°F (93.3°C).
Failure to do so may result in
injury or death to personnel.
· If personnel become dizzy while
using cleaning solvent,
immediately get fresh air and
medical help. If solvent contacts
skin or clothes, flush with cold
water. If solvent contacts eyes,
immediately flush eyes with
water and get immediate medical
· Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in a well-
ventilated area. If adhesive,
solvent, or sealing compound gets
on skin or clothing, wash
immediately with soap and water.
Use solvent to clean threads of
rod (1) and apply sealing compound.
Install inner piston (4) and
setscrew (8) on rod.Tighten setscrew
Lubricate inner diameter of outer gland (5) and wear ring (18) and seal (19) with clean
hydraulic oil. Slide outer gland onto cylinder tube (3).