INNER BOOM REPLACEMENT/REPAIR - continued

TM 10-3930-673-34

16-12. INNER BOOM REPLACEMENT/REPAIR (CONT)

(39) With carriage tilt cylinder (34) held in a vertical position, remove overhead lifting

device and lifting strap.

(40) Start engine (TM 10-3930-673-10) and extend boom so that bore in inner boom (9) is

aligned with bore at top of attachment (1).

(41) Apply thin coat of anti-seize

compound to pin (32) and install two

shim washers (33), attachment (1)

and carriage tilt cylinder (34) to

inner boom (9) with pin.

(42) At top of attachment (1), install

screw (31) and new locknut (30).

TR01691

(43) While supporting attachment

cylinder (26), extend rod end of

cylinder so that bore in cylinder

is aligned with bore of

attachment (1).

(44) Apply thin coat of anti-seize

compound to pin (29) and

connect rod end of attachment

cylinder (26) to attachment (1)

with pin (29).

(45) Install screw (28) and new

locknut (27).

TR01691

16-68.10

Change 1