 |
|||
|
|
|||
|
Page Title:
CARRIAGE TILT CYLINDER REPAIR - continued |
|
||
| ||||||||||
|
|
 TM 10-3930-673-34
16-10. CARRIAGE TILT CYLINDER REPAIR (CONT)
(b)
Place a container under gland (3) to
catch oil contained in cylinder.
1
(c)
Remove gland (3) from cylinder
4
tube (4). Pull gland out of cylinder
7
far enough to unseat preformed
8
packing (5). Allow oil to drain into
7
container.
9
5
CAUTION
3
Use care when removing rod and
6
piston assembly to prevent wear
2
ring damage. Keep rod in line with
cylinder tube to prevent binding.
(d)
Remove rod (2) and piston (6) as an
assembly from cylinder tube (4).
(e)
Place rod (2) and piston (6) as an assembly on suitable supports to prevent damage.
(f)
Remove two wear rings (7) from piston (6).
CAUTION
Do not nick or scratch seal groove during removal of seal. Failure to follow this
precaution will cause part damage.
(g)
Remove seal (8) from piston (6). Discard seal.
NOTE
Nut may need to be heated with a torch for removal.
(h)
Remove nut (9) and piston (6) from rod (2). Discard nut.
16-40
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals