16-4. MAIN CONTROL VALVE ASSEMBLY REPAIR (CONT)
Disassemble main control valve
parts (39 through 68).
Mark housing sections of valve.
These marks will be used for
Use care when removing outlet
housing and housing sections. Be
careful not to lose springs and
poppets when removing housing
Remove two nuts (39), one nut (40),
and outlet housing (41).
Remove housing sections (42 and
Remove two springs (44) and two
poppets (45) from each face of
housing sections (42 and 43).
Remove three preformed
packings (46) from housing
sections (42 and 43).
Remove two nuts (47), one nut (48), two studs (49), stud (50), and inlet housing (51).
If damaged, remove plug (52) from inlet housing (51).
Remove two screws (53), two spool caps (54), and two preformed packings (55) from housing
sections (42 and 43). Discard preformed packings.
If damaged, remove plug (56) from housing section (43).