14-3. CAB ASSEMBLY WITH ROPS/FOPS REPLACEMENT/REPAIR (CONT)
Remove four nuts (29), eight
washers (30), three washers (31),
four rubber washers (32), two
screws (33), and two screws (34) from
cab and vehicle frame (7). Discard
Remove cab assembly. Have
assistant check for any electrical or
hydraulic connections which might
have been missed and need to be
When placing cab on stands, be sure
no hoses or wires are between cab
and stands. Failure to follow this
procedure may result in damage to
hoses or wiring.
Place cab on suitable stands.
If necessary, components may be
removed from old cab and installed
on new cab assembly.
Remove turn signal switch
Remove steering wheel and column (TM 10-3930-673-20).
Remove steering control valve (TM 10-3930-673-20).
Remove transmission shifter and cables (TM 10-3930-673-20).
Remove back-up alarm switch (TM 10-3930-673-20).
Remove gauges and meters (TM 10-3930-673-20).
Remove blackout/service light switch (TM 10-3930-673-20).
Remove start/run control (TM 10-3930-673-20).
Remove horn button (TM 10-3930-673-20).