12-5. STEERING CONTROL VALVE REPAIR (CONT)
(m) Install seal (11) in valve housing (4).
Install retaining plate (10). Align
screw holes between retaining plate
and tapped holes in valve
Rotate spool (19) and sleeve (20)
assembly until pin (18) is parallel
with port face.
Install gear shaft (9). Ensure that
gear shaft engages centering
Install seal (8) in gerotor
Install gerotor housing (7). Place
gerotor housing with seal (8) mating
to retaining plate (10). Align valleys
between gear shaft (9) and gerotor
housing. Note parallel relationship
between lines A, B, C, and D.
Install star (6). Engage star and
gear shaft (9) without disturbing
relationship of components.
Install spacer (5) in star (6).
Install seal (3) in retaining plate (2).
Install retaining plate (2) on gerotor
housing (7) and align holes.
(w) Install seven screws (1) in retaining
plate (2). Pretighten screws to 150
lb-in. (16.95 N·m), then tighten to
275 lb-in. (31.07 N·m) in sequence
Follow-on Maintenance: Install
steering control valve
END OF TASK