REAR DIFFERENTIAL CARRIER ASSEMBLY REPLACEMENT/REPAIR/ ADJUSTMENT - continued

TM 10-3930-673-34

9-5. REAR DIFFERENTIAL CARRIER ASSEMBLY REPLACEMENT/REPAIR/

ADJUSTMENT (CONT)

(f)

If necessary, decrease backlash,

Step (3), (g) to move contact

patterns toward toe of ring gear

teeth.

(g)

If necessary, increase backlash,

Step (3), (f) to move contact patterns

toward heel of ring gear teeth.

(h)

Install two cotter pins (11) that hold

two bearing adjusting rings (12) in

position. Install cotter pins (11)

through boss of bearing cap (10) and

between lugs of adjusting ring.

TR00455

g. Installation.

WARNING

Minor concentrations of acetic acid

may be produced during application

of silicone RTV-732 sealing

compound. Adequate ventilation

should be provided when silicone

RTV-732 clear sealing compound is

applied in confined areas. Failure to

do so could cause respiratory

irritation, headaches and nausea.

Eye contact with silicone RTV-732

clear sealing compound may cause

irritation; if eye contact takes place,

flush eyes with water for 15 minutes

and have eyes examined by a doctor.

NOTE

TR00432

When installing differential carrier,

apply silicone RTV sealant to

bunting surface of the axle housing.

(1)

Install differential carrier (3) in axle housing (2).

NOTE

Inside of axle housing and mounting flange where carrier fastens should be clean and

dry before installing carrier.

9-30