REAR DIFFERENTIAL CARRIER ASSEMBLY REPLACEMENT/REPAIR/ ADJUSTMENT - continued

TM 10-3930-673-34

9-5. REAR DIFFERENTIAL CARRIER ASSEMBLY REPLACEMENT/REPAIR/

ADJUSTMENT (CONT)

(d)

Gap (B) of 0.015 - 0.030 in.

(0.38 - 0.76 mm) is normal between

bevel pinion bearing seal (36) and

bearing cage (30). Check gap at

several points. Difference between

the largest and smallest gap

measurement must not exceed

0.010 in. (0.25 mm).

TR00439

(e)

Install companion yoke (9) with

deflector (35), washer (32), and

nut (31).

(4)

Adjust thickness of shim pack for

new bevel pinion (29) and ring

gear (18) set.

NOTE

If a new bevel pinion and ring gear

set is installed, or if the depth of

bevel pinion has to be adjusted,

calculate the needed thickness of

the shim pack using following

procedure:

(a)

Use a micrometer to measure

thickness of old shim pack (34)

removed from under bearing

cage (30). Record measurement.

(b)

Read cone variation number on

spigot end of old bevel pinion (29).

Record number.

TR00437

TR00440

9-18