TRANSMISSION FRONT COVER REPLACEMENT/REPAIR - continued

TM 10-3930-673-34

7-5. TRANSMISSION FRONT COVER REPLACEMENT/REPAIR (CONT)

e. Assembly.

(1)

If removed, install parts (40 through 46).

WARNING

Adhesives, solvents, and sealing

compounds can burn easily, can give off

harmful vapors, and are harmful to skin

and clothing. To avoid injury or death,

keep away from open fire and use in a

well-ventilated area. If adhesive, solvent,

or sealing compound gets on skin or

clothing, wash immediately with soap and

water.

(a)

If removed, apply sealing compound to

threads of breather (46) and install on

front cover (1).

TR00234

(b)

If removed, install identification plate

(45) and four screws (44) on front cover

(1).

(c)

If removed, install oil passage cover (43) and three screws (42) on front cover (1).

(d)

If removed, install sleeve (41). Align index mark on sleeve to center of locating hole in front cover (1).

(e)

If removed, apply sealing compound to threads of plugs (40) and install in front cover (1).

(2)

Install auxiliary pump drive parts (32 through 39) on front cover (1).

WARNING

Use care when installing snap and retaining rings. Snap and retaining rings are under spring tension

and can act as projectiles when released and could cause severe eye injury.

(a)

Install snap ring (39) and bearing (37) in front cover (1).

(b)

Install snap ring (36) inside front cover (1).

(c)

Install bearing (37) on shaft (34).

(d)

Install shaft (34) with bearing (37) in front cover (1).

(e)

Use a suitable puller to pull shaft (34) through front side of front cover (1) and through auxiliary pump gear

(33) until snap ring groove is seen.

(f)

Install snap ring (32) on shaft (34).

7-46