TRANSMISSION ASSEMBLY REPLACEMENT/REPAIR - continued

TM 10-3930-673-34

(14)

Connect lead (8) to transmission

temperature switch (9).

(15)

Connect front propeller shaft (1) and

rear propeller shaft (2) on

transmission (3).

WARNING

Adhesives, solvents, and sealing

compounds can burn easily, can give off

harmful vapors, and are harmful to

skin and clothing. To avoid injury or

death, keep away from open fire and

use in a well-ventilated area. If

adhesive, solvent, or sealing compound

gets on skin or clothing, wash

immediately with soap and water.

(a)

Apply sealing compound on threads

of capscrews (6). Install rear

propeller shaft (2) four

lockwashers (5), and screws (6).

Tighten screws to 45 lb-ft

(61.0 Nm).

(b)

Apply sealing compound on threads

of capscrews (4). Install front

propeller shaft (1), four lockwashers

(5), and screws (4). Tighten screws

TR00192

to 45 lb-ft (61.0 Nm).

(16)

Ensure that transmission drain plug is in position.

(17)

Service transmission (TM 10-3930-673-20).

CAUTION

Do not start engine until both piston and tandem gear pumps are primed. Failure to

follow this instruction may result in damage to pumps.

(18)

Purge air (prime) from piston and tandem gear pumps (TM 10-3930-673-20).

(19)

Start engine and allow to run for several minutes (TM 10-3930-673-10).

(20)

Shut engine down, check fluid level and refill as necessary (TM 10-3930-673-10 and TM

10-3930-673-20).

NOTE

Follow-on Maintenance: Install transmission cover (TM 10-3930-673-20).

END OF TASK

7-41