TRANSMISSION ASSEMBLY REPLACEMENT/REPAIR - continued

TM 10-3930-673-34

WARNING

Ensure that retainer ring is secure

in groove before spring compressor

tool is removed from retainer to

prevent springs from flying out.

Failure to follow this precaution

could cause personal injury.

(f)

Press down on spring compressor

tool and retainer (91) to allow

installation of retainer ring (92).

Slowly remove spring compressor

tool.

CAUTION

TR00224

Carefully handle clutch plates so

graphite coating doesn't flake off.

Failure to follow this precaution

could cause equipment damage.

NOTE

The separator plates have external teeth and clutch plates have internal teeth. The

plates do not have a right or wrong side for installation.

(g)

Install six clutch plates (85) and six separator plates (86) into shaft assembly (77). Begin with

a separator plate and then a clutch plate. Continue by alternating plates. The last plate must

be a clutch plate.

(h)

Install retainer (84) on shaft assembly (77).

WARNING

Use care when installing snap and retaining rings. Snap and retaining rings are under

spring tension and can act as projectiles when released and could cause severe eye

injury.

(i)

Install snap ring (83) on shaft assembly (77).

7-29