7-4. TRANSMISSION ASSEMBLY REPLACEMENT/REPAIR (CONT)
(m) Use a bearing driver to press
bearing (60) onto shaft
Apply grease to three seal rings (58)
and install on shaft assembly (59).
Turn shaft assembly (59) over and
repeat Steps (a) through (m).
Assemble second stage clutch
pack (56) parts (76 through 97).
Install new outer piston seal (97)
onto piston (95).
Install preformed packing (96) onto
shaft assembly (77).
Use care when installing piston to
prevent damage to preformed
packing and outer piston seal.
Install assembled piston (95) onto
shaft assembly (77). Ensure that
piston aligns with locating pins in
Springs are under tension. Always
wear safety glasses when working
on compressed springs. Carefully
handle spring in compressed form.
Failure to follow this precaution
could cause personal injury.
Install thrust washer (94), four springs (93), and retainer (91).
Place shaft assembly (77) in a press. Install a spring compressor tool.