7-4. TRANSMISSION ASSEMBLY REPLACEMENT/REPAIR (CONT)
Using an assistant to spread snap
ring (82), use a driver to remove
bearing (81) from weld gear (80).
Remove snap ring (83).
If necessary, remove snap ring (82)
from weld gear (80).
Slide retainer (84) out of shaft
Carefully handle clutch plates so
graphite coating doesn't flake off.
Failure to follow this precaution
could cause equipment damage.
The second stage clutch pack
contains 12 clutch plates and 12
Remove six clutch plates (85) and six
separator plates (86).
Turn shaft assembly (77) over.
Use two pry bars, 180° apart, to pry
bearing (87) up and remove it from
shaft assembly (77).